What can I do if Win10 cannot install fonts?

Recently, Xiaobian's Win10 computer has a strange phenomenon. After downloading some new fonts that you like on the Internet, it always fails to install and cannot be installed. At first I suspected that there was a problem with the downloaded font, but after downloading different fonts on multiple websites, the installation failed. Win10 can not install the font how to do? Xiaobian started can not find any solution, tried to use the 360 ​​security guards to repair the system is also invalid, toss for a long time, and later in the service to open the "Windows Firewall", only solved problem. The solutions that have been painstakingly found must be written and shared. The following is a solution to the failure of Win10 to install fonts. I hope to help everyone.

Win10 can not install fonts how to do? Win10 installation fails font solutions
lead to Win10 can not install new fonts, turned out to be Windows Firewall service is disabled cause. I think of this reason later, mainly when I used the Security Guard to optimize the system boot entry, the Windows Firewall service was disabled, as shown below.

In fact, this small series a bit unjust, after disabling Windows Firewall service when the 360 ​​security guards only network printer sharing tips and relevant, did not think the font is also affected, and that 360 security guards are also present tips Some misleading, I hope to draw everyone's attention.
Win10 installation font failure solution
The solution is very simple, just enable the Windows Firewall service, if you have a security guard installed on your computer, in the boot project, start the Windows Firewall service, then Restart your computer and install new fonts.
It may be that many friends have uninstalled the security guards or did not install them on the computer. Therefore, the following teaches you another way to enable the Windows Firewall service. The specific steps are as follows.
1, open the run operation box (can be directly opened using the Win + R combination shortcut), and then type the command: services.msc After completion, click the following to open the service, as shown.

2, pull down on the right side of the service panel, find the Windows Firewall service, and double click to open, as shown.

3, the Windows Firewall service properties, the startup type to "Automatic" and click "Start" below to open Windows Firewall service is complete, click on the "OK" to save as.