Win7 system boot self-test error Floopy disk fail how to do?

The Win7 system is currently the system of choice for most users, and its maturity is getting higher and higher. Recently, the user feedback machine has self-tested at boot time, and an error message "Floopy disk fail" appears. According to the Press F1 to continue, DEL to Enter Setup prompt operation still cannot enter the system operation normally. How should we deal with this situation? The following is a small series for everyone to explain the causes and solutions.
When the self-test is booted, if this error occurs, the self-test encounters an error. You can press the “F1” key to continue, or press the “DEL”; DEL” button to enter the BIOS Setup interface to check if the settings are incorrect.
The prompt for this type of information does not indicate a true failure. It is only part of the phenomenon associated with self-test failures, as long as it is used to remind the user to choose to continue or correct the error. The real fault, the most specific and most critical, is the error before the information. The error message is as follows:
1, Floopy disk(S) fail
2, Primaster hard diskS.MARTStatus BAD
3, Primary master hard disk fail
4, System CMOS Checksum bad
5,0135:System FAN Failure
6, Keyboard error or no keyboard present
7,0135: GPU FAN Failure
8,0134: CPU FAN Failure
9,0701:USB Over Current On HC/Port
10, CMOS Time and Date Not Set<11>11, Memory Parity Error at xxxx
12, CMOS Battery State Low

Fault Cause:
1, Hard Disk Failure< Br>2, floppy drive failure
3, CMOS Setup is set incorrectly or the setting is modified
4, the current host is not connected or the keyboard is not detected
5, the host fan is not working properly
6 , USB power failure
7, host date, time error
8, memory verification error
Users with the same problem can be excluded according to the above reasons, will be able to find out the problem. If you can't solve the problem, then you should consider reinstalling the system. In this small series, it is also recommended that friends and friends should also use the system self-test function that comes with Win7 system. It is king to find problems early and solve problems early!