Mobile phone uses Win7 to carry network sharing method

Symptom:
Use computer to share wired network for Android or iOS system smartphone to use online
Solution:
Mobile phone uses Win7 system to share network access Method and common problem handling method
Test platform: win7 system, Lenovo A60 mobile phone, non-Lenovo Android mobile phone one (system version 2.3.5 2.3.7), iphone, nokia e72i (s60 v3 system)
The underlined content in the article is the setting that needs to be made when there is a problem in the operation. If the operation is successful, skip the next step.
1. Start - All Programs - Accessories - Command Prompt Right click to select Run as administrator

2. Set ssid and password
Enter netsh wlan set hostednetwork in the command line window Mode=allow ssid=The name of the network you want to create (in English format) key=The password you want to set (at least 8 digits) Enter
For example, netsh wlan set hostednetwork mode=allow ssid=alan key=12345678
< Br>3. Open the bearer network
Enter netsh wlan start hostednetwork
Normally you will see the prompt to start the bearer network

* Sometimes you may see “Unable to start the bearer network”. The state of a group or resource is not the correct state to perform the requested operation. ”

Don't worry if you see this error, please go to the Network and Sharing Center to see if the virtual wireless network connection is disabled.

Enable the wireless network connection 2 and then enter netsh wlan start Hostednetwork will succeed.

If you don't see the microsoft virtual wifi miniport in your network and sharing center, please check if you can see this device in the device manager.
This is a normal screenshot.

This is the status of no virtual wireless network card

If you can't see the microsoft virtual wifi miniport in your device manager, please reinstall the wireless network card driver.
If you still can't see microsoft virtual wifi miniport after installing the driver, please re-open the command line prompt and enter netsh wlan show drivers to verify whether the wireless network card supports this function

4. Next click the network in the lower right corner of the taskbar. The connection icon confirms whether you can see the wireless connection you just created.

*If you can't find the previously created connection named alan if you see the above picture, please re-open the cmd command line window and re-enter netsh wlan start hostednetwork You can see that connection again.

5. Right click on the broadband connection--Property to open the sharing, pay attention to select the virtual wireless network connection, ie the wireless network connection in the figure below<<>
The status of the network connection after the sharing is successful < Br>
6. The status of the mobile phone connection signal after the sharing is successful

The screenshot of the mobile phone opening the webpage

If the mobile phone cannot connect to the web after opening the webpage, please manually specify the ip in the mobile phone. Br>