If the computer can't start the 10 solutions that teach you the fault

  

1.CMOS battery failed

Chinese: CMOS battery is invalid.

Explanation: This means that the CMOS battery is almost out of power, just replace it with a new one.

2.CMOS check sum error-Defaults loaded

Chinese: CMOS found all errors when performing all checks, to load the system defaults.

Explanation: Generally speaking, this sentence is saying that the battery is running out of power. You can try another battery first. If the problem is still not solved, then the CMOS RAM may have a problem. If it is not a year. Go to the dealer to change a motherboard, let the dealer return to the manufacturer to fix it after a year!

3.Press ESC to skip memory test

Chinese: Memory is in progress Check, you can skip by pressing the ESC key.

Explanation: This is because the second, third and fourth tests of skipping memory are not set in CMOS, and the memory test will be executed four times after booting. Of course, you can also press ESC to end the memory check. But this is too much trouble every time, you can enter the COMS settings and select BIOS FEATURS SETUP, set the Quick Power On Self Test to Enabled, and then restart after saving.

4.Keyboard error or no keyboard present

Chinese: Keyboard error or keyboard not connected.

Explanation: Check if the keyboard connection is loose or damaged.

5.Hard disk install failure

English: Hard disk installation failed.

Explanation: This is because the power cable or data cable of the hard disk may not be connected or the hard disk jumper is not set properly. You can check if the connections of the hard disk are plugged in, and see if the jumper settings of the two hard disks on the same data line are the same. If they are the same, just set the jumpers of the two hard disks differently. (One is set to Master and the other is set to Slave).

6.Secondary slave hard fail

Chinese: Failed to detect slave disk

Explanation: It may be improper CMOS settings, such as no slave but set in CMOS From the disk, then there will be an error, then you can enter the COMS settings to select IDE HDD AUTO DETECTION for automatic disk detection. It may also be that the power cable and data cable of the hard disk may not be connected or the jumper of the hard disk is improperly set. For the solution, refer to Article 5.

7.Floppy Disk(s) fail or Floppy Disk(s) fail(80) or Floppy Disk(s) fail(40)

English: The floppy disk drive cannot be driven.

Explanation: The system prompts that the floppy drive cannot be found. See if the floppy drive's power and data cables are loose or wrong, or put the floppy drive on another machine. If these are all No, then I have to buy one more, but the floppy drive is not expensive.

8.Hard disk(s) diagnosis fail

English: An error occurred while performing hard disk diagnostics.

Explanation: This problem generally means that the hard disk itself has failed. You can put the hard disk on another machine and try it. If the problem is still not solved, you can only fix it.

9.Memory test fail

Chinese: Memory test failed.

Explanation: Re-plug the memory module to see if it can be solved. This problem is generally caused by the memory modules being incompatible with each other. Let's change one!

10.Override enable- Defaults loaded

English: The current CMOS settings cannot start the system and load the default values ​​in the BIOS to boot the system.

Explanation: Generally, there is an error in the setting in COMS. Just enter the COMS setting and select LOAD SETUP DEFAULTS to load the original setting value of the system and restart it.


A variety of English short sentences appear after a problem occurs during the power-on self-test. The short sentences contain very important information. You can solve some small problems by reading this information. However, these English have stumped some friends. The following are some common explanations of the BIOS short sentences. You can refer to them.

Copyright © Windows knowledge All Rights Reserved