How to set IPV6 protocol address in Win7 system

How to set IPV6 protocol address in Win7 system

The method is as follows:

1. Install IPv6 protocol: Open the control panel and go to “Network and Internet”--“Network Connection” - Right-click on "Local Area Connection", click Install in the pop-up Properties dialog box, then select "Agreement" and click Add to install IPV6 into the project list. After the installation is completed, as shown below:

2. Set the IPV6 address: Open the control panel, and then go to <; Network and Internet>- “Network Connection” - Right-click “Local Connection” In the pop-up properties dialog box, double-click "Internet Protocol Version 6 (Tcp/IP), select Manual in its property box, and enter the IPV6 address "3FFE:FFFF:7654:FEDA:1245:BA98:3210:4562” (due to IPV6 is in the test phase, so it can be freely entered to determine its address).

3. Test IPV6 settings: Press “Win+R” to open the Run dialog. Enter CMD and enter the “ipconfig” command in the pop-up MSDOS window to view the configuration of all local IP addresses.

4, configure the ISATAP tunnel, after completion, open the browser, enter the URL "http://ipv6.jmu.edu.cn/” conduct IPV6 test, on the page, if you can see A dancing tiger means you are visiting the page with IPV6. If the tiger does not dance, you will visit the page with IPV4.

windows7 tutorial

windows8 tutorial

windows10 tutorial