Computer cmd set phone wireless

        1. Turn the notebook wirelessly and the shortcut keys are different. 2.win key + R calls out the operation, enter "ldd; cmd"; enter to open the command prompt. Enter the following command and press Enter each line. Www.dnzg.cn Command 1: netsh wlan set hostednetwork mode=allow command 2: netsh wlan set hostednetwork ssid=xx key=x12345678 Note: The name of ssid here is xx, which can be changed to any identifier according to personal preference, the key is Password, at least 8 digits in length, the first digit cannot be a number. Command 3: netsh wlan start hostednetwork So far, the command part has been completed. 3. Set up a local connection network share to the xx wireless network 2 small computer in the lower right corner, click to enter <; open network and sharing center & rdquo;. Click the top left corner “change adapter settings", right click “local connection"à“property", click “share” tab, tick both hooks, select "ld" in the drop down box Network connection 2 & rdquo; (ie the wireless network represented by xx), OK. At this point, the configuration on the computer is complete, click on the small computer in the lower right corner and the Internet access named xx will appear. By default, the IP address of xx wireless network 2 we set is 192.168.137.1, the subnet mask is 255.255.255.0, and the gateway and DNS are empty. Since we will use the xx IP for the phone configuration below, just in case we check the IP of xx wireless network 2. Also click on the small computer in the lower right corner, click “Open Network and Sharing Center", in the window that appears, click on the "Wireless Network Connection 2" represented by xx. Click <;Properties", double-click <;Internet Protocol Version 4 (TCP/IPv4)", you will see the defaults mentioned above.