WinXP prompts "I can't access the function is not correct" solution

The computer will always have a variety of problems after a long time, the most common of which is the prompt "Unable to access the function is incorrect", then when you Encountered WinXP system prompts "Unable to access the function is not correct" What should I do? If you don't understand how to deal with friends, hurry and take a look at the small solution!

Description of the problem:

Today, when copying the contents of the CD to the computer with the CD-ROM drive, the data is suddenly incorrect and cannot be copied. After that, the CD-ROM drive can no longer be opened. When you double-click the CD-ROM drive letter, the total prompt: Cannot access G: The function is incorrect.

The first reason:

Burner hardware settings there is some question without some fault of the system.

The first solution:

1. Open the “Run” dialog box and enter: Services.msc. Click OK to open the “Services” dialog box, at ““ Service (local) & rdquo; found in the list "IMAPI CD-Burning COM Service" (as shown below).

2, let us take a look at this description of services: & ldquo; using Image Mastering Applications Programming Interface (IMAPI) CD recording management. If you stop the service, this computer will not be able to record CDs. If the service is disabled, any services that rely on it will not be able to start.

3, it seems that the problem is indeed here, double-click IMAPI CD-Burning COM Service to open its properties dialog box, change the "start type" to "ld"; automatic & rdquo;. (As shown below)

4, well, this problem is solved. You can also restart the system to save the settings. After restarting, right click in the resource manager. At this time, the menu will be sent to “"CD drive"

5, at this time put the CD into the CD-ROM and found that it can read the disk.

The second reason:

After the Nero Express is installed on the system, the built-in CD burning function is blocked.

The second solution:

1. Open “Run" in the system, enter Services.msc, and then pop up a "service" setting window to find Imapi cd -burning com services project, double-click the project, change the startup type from disabled to automatic, and then restart the system after confirming.

2, open “ my computer & rdquo;, select the drive properties of the recorder, in the burning tab, put "start CD recording on this device" before the tick, and then re-inserted A blank disc can be displayed normally.

The third solution:

1. Switch to another account to enter (note that the switch is not logout, if there is no other account, please go to the control panel - create one with the account account) .

2. Open the CD after entering from another account. There is no prompt for the function is incorrect, and you can check the space used by the disk and the remaining space.

3, then cut the account to the account where you have the CD-ROM error prompt, open the CD there is no "function is incorrect" prompt, after the restart, everything is done.

The fourth solution:

Uninstall the CD-ROM drive in the device manager, then add new hardware to the control panel, re-drive, if it works, it is a hardware driver problem.

The above is the WinXP prompt "can not access the function is not correct" solution, there are four ways, if it is a hardware driver problem can use the fourth method, if the built-in CD burning function is blocked The second method can be used, and the other two methods are not mentioned. Let's take a look!