How to install xp installation version under WinPE?

A.U disk boot into the WINPE system.
Second, use the virtual CD-ROM to load the system image file. The CD-ROM drive letter I assume here is A.
Three. Start, run, enter cmd, enter. Enter :cd /d A:\\i386 Enter. Enter: winnt32 /syspart:c /makelocalsource /tempdrive:c (where c is the drive letter of the XP system to be installed, you can modify it) Enter.
IV. Select new Install, ……, enter the serial number, etc., follow the steps to copy the file and then unplug the U disk before restarting, remember! !
V. After the restart, I believe everyone knows. Note: The reason why everyone did not succeed after booting is because the system does not automatically load /syspart:c /makelocalsource /tempdrive:c when double-clicking setup or winnt32, so that some files are copied to the U disk when copying files. , causing it to start. So be sure to note that you must not double-click the setup installation in the virtual CD image file or double-click the winnt32 installation. This is unsuccessful. I have tried it many times. Everyone must pay attention! !