VMware virtual machine NAT network nowhere solution

What if the VMware virtual machine NAT network cannot connect to the external network? The following system home Xiaobian will introduce you to the specific network configuration method! 1. First, confirm that the host host has enabled the VMware DHCP service and the VMware NAT service; 2. The following figure shows that VMnet1 is connected to the bridge mode, and VMnet8 corresponds to the NAT mode; 3. After the above settings are completed, the virtual machine network is usually connected. Successful, but occasionally disconnected. Solution: 1. Open the VMnet8 property page and set IPv4 as shown: 2. When the network occasionally fails, the IP address of VMnet8 is changed to other IPs in the same network segment (for example, from 192.168.143.3 to 192.168. 143.2, CentOS is automatically assigned by the system IP address is 192.168.143.128 without modification) 3. Close the CentOS network, disable /re-enable VMnet8, reconnect the CentOS network.