Common line segments and line deletion methods when using CAD

1. How to delete duplicate segments in CAD

The two segments are completely overlapped, so select: you hold down the Shift key and then click the overlapping line with the left mouse button to see if you are showing If you want to go back, if you choose, you can continue the operation below. If you don't click the mouse again, switch the line segment.

2, how to delete the repeat line in the cad graph Phenomenon: I need to find the area of ​​each graph in the graph, because there are repeated solid lines, sometimes the area will be wrong. Can the master have any good way to find out and delete it.

Downloading a ycut2006 line cutting software is done by cad. There is a function to delete duplicate lines directly! The cad software version should not exceed 2006 or else it can't be used!

3, CAD how to delete all duplicate graphics at once Use the filter command, object selection filter, set the selection conditions, add, and then follow the prompts. Just delete it.

4, CAD how to delete the middle line segment of the intersection

How to delete the three lines intersect only the triangle

Use the command “trim”

When prompted: & ldquo; select cut edge... select object or < select all >: & rdquo; directly enter.

When prompted: <;Select the object to be trimmed, or hold down the Shift key to select the object to be extended>; then click where you want to delete.

5, how to connect the repeated line segments with the straight line in CAD

How does cad link the line with the arc, and it needs a circular repeat link, which is a right angle, after rounding, will The arc is drawn once and then connected. The effect of the cut image is to cut the fillet two or three times (it is the whole, not one line)

First of all, you will draw more Connect the arcs, then click on the "Edit Multi-Line" command, then type ">J” on the keyboard, that is, merge the commands, then select the desired object, or click each object with the mouse, then, Enter, the operation is completed. At this point, you can see the results you requested. Haha, give it a try, I wish you success! 6. How did the 2004 version of cad remove the extra prominent line segments?

Using the trim command, the shortcut command is tr, see the drawing

7, how to trim the excess line in CAD

I use CAD2004, how to cross the 3 lines Remove the 2 small lines that are extra.