Win10 can not install fonts how to do? Win10 installation font failed solution

The recent Xiaobian's Win10 computer has a strange phenomenon. After downloading some new fonts that you like on the Internet, it always fails to install and cannot be installed. At first I suspected that there was a problem with the downloaded font, but after downloading different fonts on multiple websites, the installation failed. What if Win10 can't install fonts? At the beginning of Xiaobian, I couldn't find a solution. I tried to use the 360 ​​security guards to repair the system. It was not effective. I tossed it for a long time. Later, after the "Windows Firewall" was turned on in the service, the problem was solved. The solutions that have been painstakingly found must be written and shared. The following is a solution to the failure of Win10 to install fonts. I hope to help everyone.

Win10 can not install the font how to do? Win10 installation font failure solution

causes Win10 can not install new fonts, the original is the Windows Firewall service is disabled. I think of this reason later, mainly when I used the Security Guard to optimize the system boot entry, the Windows Firewall service was disabled, as shown below.

In fact, this Xiaobian is also a bit awkward. When the Windows Firewall service was disabled, 360 security guards only prompted related network printer sharing. I didn’t expect the font to be affected. This 360 security guard There are also some misleading hints, and I hope to draw everyone's attention.

Win10 installation font failure solution

The solution is very simple, just enable the Windows Firewall service, if you have a security guard installed on your computer, in the boot project, start Windows The Firewall service is OK, then restart your computer and you can install new fonts.

It may be that many friends have uninstalled the security guards or did not install them on the computer. Therefore, the following teaches you another way to enable the Windows Firewall service. The specific steps are as follows.

1, open the run operation box (can be directly opened with the Win + R combination shortcut), and then type the command: services.msc After completion, click the following to open the service, as shown.

2, pull down on the right side of the service panel, find the Windows Firewall service, and double-click the left button to open, as shown.

3. After the Windows Firewall service attribute, change the startup type to "Automatic", and then click "Start" below to open the Windows Firewall service. When finished, click "OK" below to save. As shown.

After successfully opening the Windows Firewall service, there is no error in installing Win10 fonts. If you encounter a friend who can't install new fonts in Win10, go try it.