Machine configuration: Windows7 Chinese home version, 64-bit system, Dell notebook, virtual machine Windows server 2003 Chinese version SP2
network adapter as follows
Dell Wireless 1397 WLAN Mini-Card
Microsoft Virtual WiFi Miniport Adapter
Realtek PCIe FE Family controller
The prerequisite for successful networking:
First, the device manager must have VMware Virtual Ethernet Adapter for VMnet1 and VMware Virtual Ethernet Adapter for VMnet8 (in fact, only 8 , do not need 1 also). And no problem is displayed.
Secondly, inside the control panel network and Internet network connection, in your network card properties, the VMware Bridge Protocol protocol needs to be checked (note that your physical network card, not the properties of the virtual network card, the virtual network card can be ticked)
In addition, there are no changes to the three necessary services that are restarted by default VMware in the system service.
If there is a problem with the above necessary settings, just re-run the installer and choose to repair the installation. The general problem will be solved.
Setting up the steps for virtual machine networking: (The following settings are best run as administrators)
1, open the start menu, all programs, VMware, Virtual Network Editor
2, open the NAT tab page Set VMnet Host's drop-down menu to VMnet8, write down the following Gateway IP Address, for example, my 192.168.32.2
3, open the DHCP tab, select VMnet8 in the list below, and click on the bottom right corner of the list. Properties button, write down Start IP Address and End IP Address, for example, I am 192.168.32.128 and 192.168.32.254
4, close VMware, Virtual Network Editor, run VMware Workstation, change the hardware of the virtual machine, set the network card The second mode of operation (NAT: Used to share the host"s IP address
5, start the virtual machine, for example, I am the Windows server 2003 Chinese version, and open the control panel network and Internet connection network connection
6. Change the TCP/IP attribute in the local connection property, and choose to use the following IP address. The IP address fills in the random one of the two IP addresses recorded in the DHCP page. IP, that is, from 192.168.40.128 to 192.168.32.254, just choose one, I chose 192.168.32.202. The subnet mask is automatically filled in 255.255.255.0, the default gateway and the following DNS is filled in the NAT page The IP below, for example, my is 192.168.32.2.
7, open the browser, enter http://www.duote.com/, can access the Internet.
The situation is quite special, there are two virtual Machine, and unlimited Internet access using proxy.xxxx.com
One: 192.168.32.202 Database server
One: 192.168.32.203 Application and front-end server
203 and 202 different places
203 Multiple configuration of a DNS, ip bit 202
After this,
IE connection can use the proxy to the external network, but can not connect to the database, otherwise it can connect to the database, can not be on the external network,
Solution: Click on the advanced agent behind the agent --> Enter the IP address of your database server in the exception case is not OK, enter the name of the database server, OK
So your 203 can connect to the database and can go to the external network. .