1.CMOS battery failed
Chinese: CMOS battery failure.
Explanation: This shows that the CMOS battery is almost out of power, just replace it with a new one.
2.CMOS check sum error-Defaults loaded
Chinese: Errors discovered in CMOS perform all checks to be loaded into the system defaults.
Explanation: Generally speaking, this sentence is saying that the battery is running out of power. You can try another battery. If the problem is still not solved, then the CMOS RAM may have problems. If it is not a year, it will be distributed. business for a motherboard, and after a year returned to the manufacturer, let the dealer repair about it
3.Press ESC to skip memory test
Chinese:! underway memory check, press ESC to skip.
Explanation: This is because there is no second, third or fourth test in the CMOS to skip the memory. The boot will perform four memory tests. Of course, you can also press the ESC key to end the memory check, but each time this should be too much trouble, you can choose to enter the BIOS fEATURS SETUP after COMS set, which will be Quick Power On Self Test is set to Enabled, store restart.
4.Keyboard error or no keyboard present
Chinese: keyboard error or missed keyboard.
Explanation: Check if the keyboard connection is loose or damaged.
5.Hard disk install failure
Chinese: Hard disk installation failed.
Explain: This is because the power cable or data cable of the hard disk may not be connected or the hard disk jumper is not properly set. You can check if the connections of the hard disk are plugged in, and see if the jumper settings of the two hard disks on the same data line are the same. If they are the same, just set the jumpers of the two hard disks differently. (One is set to Master and the other is set to Slave).
6.Secondary slave hard fail
Chinese: Failed to detect slave disk
Explain: It may be improper CMOS settings, for example, if there is no slave disk but there is a slave disk in CMOS, then an error will occur. At this time, you can enter the COMS setting and select IDE HDD AUTO DETECTION for automatic hard disk detection. It may also be that the power cable and data cable of the hard disk may not be connected or the jumper of the hard disk is improperly set. For the solution, refer to Article 5.
7.Floppy Disk (s) fail or Floppy Disk (s) fail (80) or Floppy Disk (s) fail (40)
Chinese: Can not drive floppy disk drive.
Explanation: The system prompts that the floppy drive cannot be found. See if the floppy drive's power and data cables are loose or connected incorrectly, or put the floppy drive on another machine and try it. If these don't work, then I had to buy one more, but the floppy drive is not expensive.
8.Hard disk(s) diagnosis fail
中文: An error occurred while performing hard disk diagnostics.
Explain: This problem generally means that the hard disk itself has failed. You can put the hard disk on another machine and try it. If the problem is still not solved, you can only fix it.
9.Memory test fail
Chinese: Memory test failed.
Explanation: Re-plug the memory module to see if it can be solved. This problem is generally caused by the memory modules being incompatible with each other. Let's change one!
10.Override enable-Defaults loaded
中文: The current CMOS settings cannot start the system and load the default values in the BIOS to start the system.
Explanation: Generally, there is an error in the setting in COMS. Just enter the COMS setting and select LOAD SETUP DEFAULTS to load the original setting value of the system and restart it.
A variety of English phrases appear after a problem occurs during the power-on self-test. The short sentences contain very important information. Reading these information can solve some small problems on their own, but these English are difficult to solve some friends. Here are some explanations of some common BIOS phrases. You can refer to them.