1, Win8 system image
2, Windows To Go auxiliary software multi-thread optimization special version
(the above documents, the end will be provided)
Well, let's start! First we must first extract win8 image The install.wim of the sources folder, you can use WinRAR to extract simple and convenient.
Then plug in our U disk (or mobile hard disk), use the system's own disk management to set the U disk to "active area", this step is very important, if not set, it may cause the U disk boot can not boot the system Right click on the mobile drive letter and set it to “activity"!!
Open the Windows To Go auxiliary software (win7 users please run with “ administrator privileges), select the installer that was just unzipped. Wim file, “Select the installed disk” this, select your own U disk or mobile hard disk, here you need to pay attention to, the storage device must be greater than 20G space! Otherwise there will be tips! Storage device is still recommended USB3.0 specifications.
less than 20G will be prompt Oh! after
have been selected, click it to start the installation! automatic, without manual intervention. After the start, the software will automatically format the memory, so what information is still backed up in advance. Then pop up a CMD command line ~ there will be a progress bar and time estimate, please wait a moment!
It is strongly recommended to use the multi-threaded optimization version recommended in this article, this will reduce the installation time of this step, 3.0 device installation install .wim time is about 20 minutes! Please be patient, don't close the command line window!
When everything is installed, the CMD command line will disappear automatically. We will close the software, restart the computer, and enter the Bios settings. Under the item~ The motherboard of each computer is different, you can check your motherboard manual for modification.
The following is an example of my Lenovo desktop. After rebooting, click the DEL button to enter the Bios settings.
According to the figure, select the second item on the left.
Next select Boot Device
1st Boot Device item selection, Removable Dev
You can enter Removable Dev to confirm whether the motherboard can be recognized!
Good After the setting is completed, save and exit, you can see Win8 after rebooting!
The step of installing win8 to U disk is over, the system is installed to U disk (or mobile hard disk is also available), carry it with you Where to go to plug in the U disk, everything is done! Don't worry about the synchronization of the files, don't worry about personal habits, don't worry about security issues, everything is as simple as that!