Win7 system prompts configuration windwos update failed to restore changes cause the computer can not boot three solutions

win7 system needs to be updated every time, sometimes win7 Ultimate system encountered update failure can not boot into the system, how to do it? “ Configuring windwos update failed to restore changes, do not turn off the computer & rdquo;, how to solve it? The following Xiaobian share win7 encounter update failure prompts "Configure windwos update failed to restore changes, do not turn off the computer" solution.
Fault reason analysis:
1, our computer system version crashed when the background update and upgrade;
2, or our anti-virus software software crashed when updating.
Solution 1: Enter safe mode, close update <1> 1, restart the computer and press f8, go to the advanced startup option, select [safe mode] to enter;

2, after the security mode, Point to the computer, right click properties. In the lower left corner, open ”windows update";

3, then click to change the settings;

4, select “ never check for updates & rdquo; and remove “ allow all computers User install update & rdquo; selected state. OK, and restart to see if you can enter smoothly.

Solution 2: Restore the system
1, if the system has set the system restore point before, you can directly restore the system! However, it is recommended that unless the first method is not available on your computer, it is recommended to use the first method!
2, so that you can enter the system normally, and also solve the problem that the system update fails to enter the system. For Xiaobai, it is recommended not to enable update. If there are system updates and patch files that need to be updated, third-party security software can be used for maintenance.
Workaround 3: If the computer system update caused by anti-virus software or computer guardian software prompts the problem
we can let them slowly update when the computer is idle, of course, in the update At the time, the computer will become very sluggish and very cardy, but don't shut down and restart at this time, wait until the update is complete. If the computer is restarted after shutdown, because the updated program is not completed, it will appear: configure windows update failed to restore changes.
Related reading:
Windows 7/8 How to escape windows update when installing new hardware? Detailed explanation of the solution
The above is the introduction of the win7 system prompt configuration windwos update failure restore changes cause the computer can not boot all the contents of the introduction, there are users who encounter the same situation can refer to this tutorial.