What should I do if the new install win10 card is starting up?

A lot of friends have just started the installation system and waited for half a day to get stuck in the installer. I have encountered a way to share it with everyone today. I hope it will be useful to everyone

Method one:

1, use the installation image of the original WINDOWS to boot to the installation interface, press the shift key +f10 to call out the cmd menu and input diskpart, then enter the list disk to display your existing disk as shown below

2 There are two hard drives here, so you can see disk 0 and disk 1, then type select disk 0 (choose the disk you want to install the system, if your system disk is disk 1, type select disk 1) and then see the disk 0 is now the selected disk, then enter clean, wait a few seconds and you will see diskpart.

Successfully cleared the disk prompt, and then enter convert mbr, you will see that diskpart has successfully changed the selected disk to mbr format, and then reinstall the system to enter the desktop. . .

Method 2:

1, the original hard disk is now GPT format. Install the Windows system yourself and convert it to MBR format with commands. Or directly delete the whole disk, and then create a new one, you can install it normally

Note: Converting the disk format requires clearing all the partitions and data on the disk. Before operation, please save all important data on the disk.

Related knowledge: GPT format is changed to MBR format

1. Use Win7 CD or U disk to boot and enter the system installation interface.

2, press Shift + F10 to open a command prompt.

3, input & rdquo; Diskpart & rdquo; (without the quotes, the same below), and press enter into the interface

4, input: & rdquo; list disk & rdquo ;, view disk information. Pay attention to the disk capacity to choose. In the figure, Disk 0 of 465G is a hard disk, and Disk 1 of 3852M is a USB disk for Win7 installation.

5, input: & rdquo; select disk 0 & rdquo ;, selected disk 0 is the current operation disk

6, input: & rdquo; Clean & rdquo ;, clear the current partition .

7, input: & rdquo; convert mbr & rdquo ;, convert MBR partition.

8. operation is completed, close the command prompt, the system can continue Win7 installation according to the normal method.

Extended knowledge: Other uses of the convert command:

convert basic - Converts a disk from dynamic to basic.

convert dynamic - Converts a disk from basic to dynamic.

convert gpt - Converts a disk from MBR to GPT.

convert mbr - Converts a disk from GPT to MBR.