Experience in recovering hard disk system clones

At present, cloning hard disk systems (usually C drives) has become a fashion move. Therefore, the operation of restoring clones has become increasingly commonplace. However, improper operation is also very dangerous. This article takes the Ghost 6.0 software widely used now as an example, according to the author's practice, introduces relevant experience for your reference.

Imitation of MS-DOS environment is good or bad;

Usually, the software can be cloned in a window environment (such as Win 98), recovery clone should be in pure DOS (non- The window environment is simulated under the MS-DOS mode.

At first, I used it several times in the imitation MS-DOS mode of the window environment. It was good or bad, not too concerned. ;

The mouse slipped into a big disaster;

Later, several serious problems occurred. The content of the C disk that should be restored, the result covered the D disk, causing the content of the disk to be completely annihilated. Analysis of the reason, it is estimated that the mouse slides down, originally the eyelids saw the choice of the C drive, may click the mouse moment, the arrow slides down to the D drive below, due to the recovery operation immediately began, covering up the essence of the problem.

So, every time you use the "restart the computer and switch to MS-DOS mode" operating environment, then there is usually no mouse (preferably do not use the mouse), no serious problems above. ;

System floppy disk boot Everything is fine;

It’s not a long time, and there have been new strange problems recently. Please see the following fault example:;

Example 1: A Pentium 3/450 original machine, after the recovery clone operation is finished, an error message is displayed, and the recovery clone is refused. Several .GHO files backed up by this machine have been restored in the past.

Example 2: A Pentium 3/1G original machine, after the recovery clone, the machine access to the internal LAN of the enterprise is normal, after modifying the IP parameters, access to the external LAN of the enterprise is not normal. After inspection, the network cable, hub, switch, etc. are all normal. ;

Troubleshooting: Start with Win 98 system floppy disk, quick start (press F5 key) or drive with CD-ROM drive. In this environment, the recovery clone operation is performed and everything is back to normal.