Xp automatically restart after shutdown. What should I do?

Let it shut down but restart

This fault is the most common failure in Windows XP operating system shutdown failure. The cause of this failure may be due to the following reasons:

1. The system settings are in the confusion

Windows XP defaults to automatically reset when there is an error in the system. Start, so that when the user shuts down, if the system fails during the shutdown process, the computer will restart. Turning this feature off often resolves the failure of an automatic restart.

Right click on “My Computer& rdquo; on the desktop, select “Properties> in the pop-up menu, pop-up "System Properties& rdquo; window, click &ldquo ; Advanced & rdquo; tab, click on the "Start and Recovery" column in the "Settings" button, pop-up "Startup and Recovery" window, as shown in Figure 1. In the “System Failure” column, remove the checkmark before the “Automatically restart” option, and click the “OK” button.

2. Advanced power management in the ghost

As we all know, shutdown is closely related to power management, the cause of the shutdown failure is likely to be power management to the system support Not good.

Click “Start & Rarr; Settings & Rarr; Control Panel & Rarr; Performance & Maintenance & Rarr; Power Options & rdquo; In the pop-up window, enable or disable “ Advanced Power Support as needed. If you are using "Enable Advanced Power Support" when the failure occurs, try to cancel it. If the failure occurs, you are using the cancel "advanced power support" and try to enable it. Will be solved.

3. USB devices are not worrying

Now when USB devices are popular, what U disk, mouse, keyboard, modem, etc., are all available. As everyone knows, these USB devices are often the main culprit for shutdown failures. When a shutdown turns into a reboot failure, if you have a USB device attached to your computer, please unplug it and try again. If you are sure that the USB device is faulty, it is best to replace the device or connect it. An external USB Hub connects the USB device to the USB Hub instead of directly to the USB port on the motherboard.