A hard disk can be said to be one of the more easily damaged hardware in computer hardware. Therefore, in the process of computer maintenance, computer failure due to hard disk problems is also very common. For many computer users, although the hard disk is not the most important, the data stored on the hard disk may be very important. Once the hard disk is damaged, it will cause a lot of trouble. Then, if the hard disk is broken, can it be repaired? How to fix it? These are topics that are very interesting to many computer enthusiasts. Today, Computer Pepsi.com will use a hard disk repair example to teach you how to repair bad sectors of the hard disk.
hard disk is broken how to repair how to repair bad sectors of the hard disk
This article describes the hard disk repair method, mainly for some relatively simple hard disk repair, if the hard disk is connected to the computer, it is not recognized in the BIOS. So, then this kind of hardware is basically completely damaged, the ordinary method is basically unable to be repaired. If the data is very important, it is recommended to find a professional data recovery center. This article is only for the hard disk has a lot of bad sectors can not be used, but the hard disk can be recognized in the computer BIos.
Hard Disk Repair Preparation Tool:
1, a computer that can be used normally
2, a U disk one
3, a faulty hard disk
A hard disk is broken How to fix the tutorial
1, first Make the U disk into a boot disk. You can use the software such as “Computer Store”, “Old Peach” or U Master to make the U disk into a boot disk. The production method is very simple. This is a lot of U before us. The disk installation system tutorial has a detailed introduction.
Do not know the production method friends, please read: computer store U disk boot disk production graphic tutorial or old peach U disk boot disk production graphic tutorial
2, after making the U disk boot, we close again After the computer is turned off, then insert the created USB flash drive into the computer, and install the damaged hard disk into the computer, then restart the computer and press the Del key to enter the BIOS settings, and then set the first boot item (Tutorial: Set the computer to boot from U disk boot detailed method), after completion, restart the computer, we can enter the U disk to start, then select the amount to enter the PE system, as shown below:
enter the PE system
3, enter the PE system After that, we can see on the desktop that there is a “DiskGenius hard disk partitioning tool”, we click into DiskGenius, we must see that this hard disk can be detected inside. If it is not detected, the basic hard disk can no longer be used. It's free to fix it in the usual way. Usually if the hard disk is not serious, we can still recognize the partition if it enters the DiskGenius tool, as shown below:
Check whether the hard disk can be recognized by the computer
As shown in the above figure, the faulty hard disk remains. Can be recognized normally, it is better to fix this situation, we can try to repair the hard disk.