WIN7 system prompts that the damaged file cannot be read and analyzed

When the computer is in use, it will inevitably encounter some system error problems. Recently, users have found that the file in the lower right corner of the win7 system desktop has a "damaged file" error message, which may cause some programs to be unreadable. If you pay attention to it, there may be more serious system problems. What is the cause of file corruption? How to solve it?
If the above phenomenon occurs, most of the hard disk partition table is damaged, resulting in partition information of the hard disk. Can not be read correctly by the system, there will be an illusion that the hard disk has not been formatted when it leaves the factory. If you still want data files on your hard disk, please do not write or format the hard disk at this time. Find a data recovery tool that supports RAW format. Such as easyrecovery, you can find back those precious data. Of course, this process needs to be operated in another hard disk with no problem. The faulty hard disk is hanged as "from disk". The following are some other solutions found on the Internet, and some are soft faults with permissions issues.
Windows7 system appears under the "damaged file" prompt solution is as follows:
First, you can see the prompt content on the win7 system, determine where the file directory, is due to what program caused. As shown in the figure below, the picture shows the Awc.exe-damaged file. Here you can also see the specific path of the file corruption. The information here has been told in great detail that the corresponding program in the corresponding directory is corrupted.

Second, use the processing scheme given by our win7 system, run the chkdsk tool to solve this problem. In the start menu, we start the run dialog directly, and then enter the CMD command to open the command prompt.

3. Then in the win7 system command prompt, enter the command chkdsk /f, and then press the Enter key to fix it. In the prompt that pops up below, select Y, and then close the window. At this time, everyone has to restart the computer, and then run the program just now.

It is worth emphasizing: Be careful not to format and then use the software to scan the hard disk, because formatting will only destroy the data again. It doesn't make sense to restore. Try not to use this command. If you must use this command, please backup it first. Good MFT or mirror the entire partition. Because CHKDSK repair has certain risks, it is possible that the repair failure will result in complete loss of data.
About the system pop-up "damaged files, can not read" error prompt window is introduced here, I hope that through this article to introduce a more in-depth understanding of the damaged files encountered by everyone.