Master! After using Windows to bring the disk repair, after the restart, it is stuck

Masters! After using Windows to bring up the disk repair, it will be stuck after rebooting.



This disk cannot be used. The physical damage is serious and the detection is not passed.






The system may be damaged. I suggest you reinstall the system.






Re-doing the system






The original partition was lost due to an operation error. If your partition structure is special, simply using partition recovery software will not necessarily find the correct partition data. The wrong reconstruction will destroy the original partition information and cause recovery difficulties. If it is a notebook
partition is often special. If you are familiar with data recovery, this situation can be recovered very simply. Now the computer can start the Internet normally, and the original data can be directly restored by remote assistance. The correct operation can be done without reinstalling the system. Never write large amounts of data to the current hard disk. So as not to destroy the data that may be recovered. Do not repartition, format, etc. In that case, the recovered data is incomplete. keep status quo. The correct analysis and processing is largely a complete recovery of the original data. No data recovery software scan recovery is required. Simply using data recovery software to scan and recover, it takes time and the effect is hard to say. If you want to try to recover yourself, refer to Scanning Recovery with Data Recovery Software, remember not to write the found files to the hard disk where the problem occurred. Instead, restore the found data to another hard drive. Once the problem is correct, the problematic partition is processed.