How does Win7 open the telnet command?

  

Under the Win7 system, when the test port number is normally open, we always use the telnet command to test. But recently, some users have reported that when using the telnet command in the cmd command line, the telnet command will always be found. In fact, there will be such a situation because the telnet command is not enabled. Below, Xiaobian will tell you about the method of opening the telnet command under the Win7 system.

Method /Steps

1. In the start program, open the Control Panel.

2. In the Control Panel, click the “Programs” option.

3. Under Program Options, click “Open or Close Windows Features”. Start the telnet client service.

4. In the dialog that opens, find “Telnet Client> and check it. Then click “OK", wait a few minutes, the system will open the telnet client service for you.

5. In order to verify whether the Telnet service command is successfully enabled, you can test it under the cmd command line. At this time, you will not be prompted to find the telnet command.

Copyright © Windows knowledge All Rights Reserved