Win7 64-bit pure version of the system under the slow response of the mouse

1, the fault caused by the disconnection of the chip cable
The main performance is when the cursor is good or bad or the cursor does not move, the cursor will shake when you push the connection by hand .
Solution: First disassemble the mouse, unplug the cable cable plug from the circuit board, and then mark the corresponding relationship of the pins and the color of the core wire. When the wire is pressed, the core wire is at the broken position. Cut off a section and use a hole-shaped pin and a crimper to press the wire as it is.
2, may be optical mouse failure, positioning is not allowed
Optical mouse is more frequent occurrence of mouse failure positioning is not accurate, the performance of the mouse often appears for no reason to shift phenomenon, the mouse positioning is not allowed.
Reason analysis:
1) Optical mouse is very good for the pursuit of beautiful and beautiful outer casing. If the optical path is not well shielded and affected by external stray light, plus strong light interference around, This will generate interference pulses that cause the mouse to malfunction.
2) If the temperature is too high, the crystal or IC operating frequency will be unstable and drift.
Solution: Replace it with an integrated circuit or crystal of the same type and frequency.