Win7 prompt "load driver" solution

There is usually setup.exe or install.exe in the driver's directory. You can install the driver by double-clicking it. If not, right click on the device to be updated, update the driver, select the option below, assign the directory to the driver's unzipped directory, and the system will automatically install the driver. There is no driver for win7 now, usually with Vista driver is OK. If you don't have it or can't install it, download a driver wizard or drive life, it will automatically find the matching driver online.

Question 1:

My installation environment is hard disk installation under WINXP. As for the installation method, here is a brief description:

Copy the file in the ISO image BOOTMGR And BOOT, EFI two folders, and BOOT.WIM under SOURCES (located in the SOURCES directory of the C drive), extract the ISO image file to other hard disk partitions such as F:\\\\win7, run the following command:

C:\\\\boot\\\\bootsect /nt60 C:

The system will go into the installation win7.

According to the tutorial
on the network, I entered the system repair during the installation process, and formatted the C drive again, then run F:\\\\win7\\\\setup. Exe into the installation, this time there is the need for win7 "load the required driver", there is no way to enter the next step.

Solution: Carefully study the tutorial on the network, found that after formatting the C drive, the program is F:\\\\win7\\\\sources\\\\setup.exe, this and the setup size I used before is There is a difference, this time to install, just select the partition on the line, do not click "Load Driver" to enter the next step, the installation below is no problem.

Description: After formatting the C drive (or deleting some files copied before the C drive), restarting the system will find that the installation interface cannot be entered. At this time, you can run the CD. Version Operating System
WinPE, re-copy the file to the C drive, and then run the command to restart.

Question 2:

To install the image file on the virtual machine with the CD-ROM drive today, the CD-ROM drive is D: disk, the hard disk is not formatted, whether it is from X:\\\\sources or root directory X: The setup.exe can not be installed, if it is installed from D:\\\\sources\\\\setup.exe (Note: In the system repair), enter the command line, DOS interface, there is an X: disk path and The actual disk D: disk path where your installation file is located, you can not find the setup.exe file. It is obvious that the method of Question 1 did not solve my problem.

Now I finally found the problem on the installation image file, carefully compare the source file (the installation file is downloaded and stored on the server, and then copied to the local machine) and the installation file, found 2 file sizes Inconsistent, probably some problems occurred when I copied, but it can run successfully during the installation, and will not verify that the installation file is complete, and will not report the file error prompt, now use the source file to install again And finally succeeded.

Summary of the problem of this loading driver:

1, run X:\\\\sources\\\\set.exe can be solved;

2, the installation file itself There is a problem, this is difficult to distinguish, it is best to verify that the MD5 value of the installation file and the MD5 value of the downloaded source file are consistent. It is definitely not possible to change a version.