How to use DiskGenius to fix the load failure

Discovering problems

The problem with the author is an old-fashioned desktop computer. According to the above-mentioned "error", the prompt is that the computer is booting, the system It could not be loaded correctly, which caused the computer itself to fail to boot the Windows system.

According to analysis of the problem at our disposal to prompt the computer to analyze what can be from several considerations. The first is the possible failure of the hard disk. This involves hardware problems. If the final confirmation is the hardware problem of the hard disk, it is recommended to test the hard disk after replacing it. Secondly, from the perspective of the system (software), that is, when Windows starts up. The boot sector required for booting cannot be found. Simply put, the sector of the main boot disk of the system C disk (generally) is damaged or the boot information is disordered.

Solution Start the Windows PE system, and use the software tools to smooth out the messy startup information in the PE system and repair the damaged sectors in the main boot area.

Note: The software used is as described above. DiskGenius is an installation-free version. It can be used after being downloaded directly to the local and decompressed. Using DiskGenius to repair the system to load the fault

Many people think that the analysis of the solution mentioned in the previous paragraph, usually need to be repaired under the Win PE system (CD or USB version). In fact, there is nothing wrong with the use of the rich tools of the system in the Win PE system, such as the disk master can be repaired. Download the old peach U disk boot disk creation tool

But from the perspective of the average user, running the program through the command in the dos interface is obviously much more difficult than using the program under the Windows interface we are all familiar with. . Therefore, in order to ensure foolproof, we started DiskGenius in this PE system to fix it.

reconstruction select the master boot record (MBR)

rebuild the master boot record (MBR) that is guided mainly failed to re-boot the PC system calibration, set forth herein The root of the fault is the order of the MBR. With accurate guidance, the system can enter smoothly when it starts.

confirm the re-establishment of the master boot record

DiskGenius during the normal operation under the respective extents, as shown above will be displayed, when the user confirms as to which a hard disk When the master boots the MBR, click “ is ” OK. Then keep DiskGenius out.

Note: Here you need to be prompted, in the external Windows PE system, we need to use another U disk, put DiskGenius into this U disk, plug in the computer USB interface, open and run in the PE system DiskGenius, to do the above.

Windows XP resume normal use

After the above operation uses one by one, we will restart the computer (U disk can recede and the PE system reboot process). After a few seconds, we will see the entry into the Windows XP startup prompt as shown above, which shows that the re-establishment of the MBR master boot record we performed earlier.

Summary: I have tried to restore the system to the Ghost system using the DiskGenius repair system, but after restarting the restored system again,  error” appears again, which indicates that Ghost recovery is normal. NBR can't solve the problem (unless the computer partition is fully formatted, use the CD to directly install the computer). However, the data in the computer disk will be deleted, and the cost is relatively large. If you are experiencing the same problem, you may wish to try it out according to this method. The data is priceless. I wish you all success!