Win7 computer boot scan hard disk blue screen how to do?

We know that every time the computer is turned on, the hard disk will be scanned during the process, and each partition will be scanned. This is a necessary step for the system every time, and it is also necessary for the security of the system, but recently there are many friends. It is found that ghost win7 often has blue screen failure when performing disk scan, and even causes the computer to crash and restart. Then, how can we solve this situation? Below, Xiaobian will explain this problem to everyone!

analysis: we know that in the system to change from xp win7 system, we are told, win7 system installed for the computer's configuration requirements are relatively high, in fact, not only for computer software configuration The requirements are high, and the hardware requirements for the computer are not low. If the quality of the hard disk is not up to standard and the bad track is cleared, it may cause a blue screen failure after booting.
Solution:
1. Since it is caused by the quality of the hard disk, then our best way is to replace the hard disk of the computer, of course, we need to replace the data cable.
2. Or, let's try to replace the chassis power. If the computer malfunction still exists, we can only replace the motherboard. In general, the worst plan is to replace the motherboard.