How to connect wirelessly with dual routes? TP-Link wireless router to open WDS bridging method

Going out, no matter where in the city, you can receive some connected or encrypted WiFi signals, but most of the signals are not strong, some companies wireless Even if the route is far away from some distance, the signal is very weak. If you have two wireless routers, you can let WDS bridge the wireless signal when there is only one broadband, which can make the huge office have a smoother wireless network. Read below to learn how the TP-Link dual wireless router turns on WDS bridging.

on view of a small business wireless network, A, B, C sectors If only three wireless routers 1, there may be some weak or computer search to FIG signal The signal could not be searched and the wireless network could not be connected. The solution is: A, B, and C departments each connect to a wireless router, and the three wireless routers can achieve perfect coverage of the entire area and eliminate blind spots through the WDS connection.

Configuration idea: Wireless router B acts as the central wireless router, and wireless routers A, C and wireless router B establish a WDS connection.

The steps are as follows:

First, the central wireless router B settings

1, login wireless router settings B management interface, set in the wireless settings - basic settings “ SSID number & rdquo;, & ldquo; channel & rdquo ;, FIG:

2, the & ldquo; wireless setting & rdquo; & mdash; & mdash; & ldquo; wireless security setup & rdquo; provided a radio signal encrypted information;

If the delay is too serious a network receiving over 11 use the channel

3, after the wireless router recorded SSID setting B, and the encryption setting information channel, disposed subsequent wireless router a, C of Need to apply.

Second, wireless router A settings

1, modify the LAN port IP address. In the network parameter-LAN port setting, modify the IP address and B router differently (prevent IP address conflict), such as 192.168.1.2, save, the router will automatically restart.

2, enable the WDS function. After the reboot is complete, log in to the wireless router A again with the changed LAN port IP address, and tick "WDS" in the Wireless Settings - Basic Settings. Note that the SSID here is not the same as the B router. Of course, it can be set to the same, so you can roam within the coverage of these three routers, that is, as long as you are free to connect to the network within this range. Another point in this range can also access the Internet without reconnecting. Re-entering the SSID is very convenient. The three routers form an identical large network.

3, WDS settings. Click “Scan” to search for surrounding wireless signals.

4, the scan signal to the selection list in the SSID router B, as shown in TP-LINK_841_B, click & ldquo; connected & rdquo ;.

5, the channel set to the same router and B channels.

6, the same encrypted information and setting router B, & ldquo; Save & rdquo ;.

7, turn off the DHCP server. In the DHCP server, select “do not enable ”,“save” to restart the router.

8, A wireless router configuration. At this time, the wireless router A and the wireless router B have successfully established the WDS.

Third, wireless router C settings

The setting method is the same as that of router A (IP address must be the same as routers A, B and other computers in the network, otherwise it will cause IP conflict computer Unable to access the internet).

The above is the method for the TP-Link dual wireless router to enable WDS bridging. The dual-route WDS wireless bridging requires an accurate IP address. This method can also perform multi-route WDS bridging, but the more connected routes, The network impact of the router receiving the WDS side is greater.