How to achieve two hard disk mutual copy of win7 system

How to achieve two hard disk copying in win7 system computer

1, select two hard disks. It is best to put the hard drive on the SATA1 above. In this way, you can distinguish between primary and secondary when you enter GHOST;

2. After entering GHOST, press [Enter] on the keyboard;

3. Use the up, down, left and right keys on the keyboard. Select [Local]---[Disk]---[To Disk]---[Enter];

4. After entering [To Disk], you can identify all the storage devices of the motherboard. The serial number 1 is the disk that was started. The back is SATA1 SATA2 on the hard disk;

5, use the up and down keys on the keyboard to select the data hard disk and then press the Enter key or use the [Tab] to switch to [OK] and press Enter;

6, GHOST jumps to the same interface as the interface. The difference is that there is an item that is gray, and the gray one is a clone disk. Can be cloned to the hard disk. Use the up and down keys on the keyboard to select the data hard disk and press the Enter key or use the [Tab] to switch to [OK] and press Enter;

7. The clone disk partition shown below. Use the up and down keys on the keyboard to select the data hard disk and press the Enter key or use the [Tab] to switch to [OK] and press Enter;

8. Display the clone to the hard disk partition. Use the up and down keys on the keyboard to select the data hard disk and press the Enter key or use the [Tab] to switch to [OK] and press Enter;

9, [OK] to perform disk cloning;

10, start cloning.