Win7 computer can not enter the router how to do

  
        Many times, when we encounter network connection problems, we need to enter the router to set up, and our wireless network is turned on and off, the traffic used by the host connected to the network, the limited router information, etc. are all required to enter the router. Set it up, but if you find that your router can't enter, what should I do at this time? Below, let's take the win7 64-bit flagship version as an example, let's introduce it to everyone!
1. First, let's do it. Connect your computer to the network, connect the router to it, and take the ADSL cat out.
2. Next we find the local connection icon in the computer, right click, enter the property window, double click to open the IPV4 protocol version, and set the IP address to 192.168.1.10 or 192.168.0.10, the subnet below The mask is set to 255.255.255.0, the default gateway is set to 192.168.1.1 or 192.168.0.1, DNS is set on the Internet according to local conditions, and finally click OK to save the settings.
3. After completing the above settings, let's open the browser again, enter 192.168.1.1 in the address bar and click Enter. This should enter the router's settings interface. After you enter the router's account password, You can go to the page to set the relevant data.

Copyright © Windows knowledge All Rights Reserved