SSD ReadyCache's simplest computer acceleration solution

The emergence of solid-state hard disk, let the computer really enter the era of rapid development. In the past, no matter how many configurations of the computer were dragged down by the mechanical hard disk, the performance was low because of the slow speed, the software was started, etc. Now there is a solid state hard disk. System disk and cache disk can solve this problem.
The difference between solid state hard disk and ordinary hard disk: Compared with traditional hard disk, solid state hard disk is the last hardware of the five major components of the computer and Moore's Law. It is completely composed of NAND memory chip, through high and low level and changing transistor switch. State to store data. The inside of the conventional hard disk is composed of a disk, and the positive and negative magnetic poles on the disk are rewritten by the magnetic head to store data.
The most important difference is that the performance of the SSD can kill a few ordinary streets, in addition to SSD in other aspects than the HDD, such as the size and weight of the SSD wins, SSD completely silent without vibration, lower temperature , lower power consumption.
Getting Started SSDs (experience faster performance with minimal cost) Since current SSDs are too expensive and have a small capacity, most users use it to install systems and cache disks. I believe that some high-end computer configuration users have used SSDs and experienced the computer speed improvement effect brought by SSDs.
The old configuration computer users want to spend less, let the computer rejuvenate life, you can choose the Flash Dimensional entry-level cache solid state drive - SanDisk ReadyCache.
































The disk is used to significantly improve the user experience of using mechanical hard disk. In fact, many Ultrabooks currently have ExpressCache.



























It is enough to use as a cache.
ReadyCache Installation:
ReadyCache comes with a stand and data cable that can be installed directly on the desktop. It is recommended to plug in the SATA3 interface and enable AHCI (if supported).




























Installing ReadyCache SSD does not require partitioning and formatting. After installing ExpressCache, it will automatically create a cache when running directly. It is recommended to start the common software again, and then restart the system several times. Currently ReadyCache supports Win7 and Win8 systems.

The principle is to cache the software you commonly use to the SSD. The next time you run it, the speed is fast, reducing the reading and writing of the mechanical hard disk. It's a bit like FancyCache, which was introduced earlier, but FancyCache uses memory to cache.



from the resource monitor to see the cache hit is still very accurate