Win7 system boot screen always shows the solution of the enterprise power save mode

Solution:
1, you can first try to disconnect the data cable of the monitor after removing the power (remove the two fixing screws);

2, if the display enters the power saving mode, it is possible Did not receive the instructions issued by the system, here are also divided into several situations, separately. For example, if you use the computer for a long time, you have never cleaned the chassis, and there are many dusts, which cause static electricity and power failure. Take measures: turn off the power, clean the chassis;

3, some brands have electrostatic protection devices, in case of such problems, first power off, then remove the power plug, then long press the power switch (or press A few power switches), power on again later, this will also clear the computer self-locking state;

4, there is a BIOS exception, such as the network startup mode, you can try to restore the BIOS default value. Power-on button (different computer keys have different values), usually the first interface will have a prompt for relevant key values;

5, some brand machines now have no key-value prompts, because a boot is displayed Brand logo;

6. For example, after some models enter the BIOS, find Power Saving Mode in POWER MANAGEMENT SETUP set to Disabled, then press F10 to save the settings and exit the BIOS, restart the computer;
< Br> 7, if you can not find the setup menu, you can restore the BIOS defaults (the steps will also vary depending on the BIOS version).
For example, the BIOS setting of ASUS computer is set to the factory default setting method: press Esc key, find Lood setup Defaults (some BIOS options are: Load Optimized Defaults Setting), press Enter to confirm;
8, if it is set by the monitor The problem (mostly happening in the desktop) can be set in the display's setup menu (or set to the default value);

9, if there is a prompt at boot, but still can enter the system later, You can enter: powercfg.cpl → OK;

10, set the device under the state of power-on [never] → save and modify.

The above is the introduction of the solution to the enter power save mode of the win7 system computer boot screen. If you encounter the same problem, you can solve the above method.