for U disk boot disk creation If you want to use the U disk to start the computer installation system, take a look at this tutorial. The tutorial describes how to make a U disk boot disk, how to set the computer to U disk boot and how to use the U disk boot disk to install the operating system. The conditions required to make the U disk boot disk a, U disk one, at least 128MB b, WinPE image ISO or U disk boot disk creation tool (can be downloaded on this site, there are addresses below) c, U disk support U disk boot computer U disk The boot disk creation tool is recommended to download two versions: a, Chinese cabbage U disk boot disk creation tool b, general PE toolbox, download address specific method of making U disk boot disk: Take the general PE toolbox as an example, because Chinese cabbage The U disk boot disk creation tool is a one-button U disk boot disk, which is very simple and does not need to be introduced. 1. First insert the USB flash drive into the USB interface of the computer (important note: the USB flash drive will be formatted during the production process, pay attention to the backup data); 2. Unzip the downloaded WinPEU.rar file; 3. Open the UltraISO in the decompression directory of WinPEU.rar. Exe program; 4, in the open UltraISO program interface, double-click to open the WinPE.iso CD image file; 5, then select "Start CD" in the top menu <; & ldquo; write disk image & rdquo;; 6, in “ In the hard disk drive, select the USB flash drive you want to make as the boot disk (the software selects the USB flash drive by default, it will not operate on the hard disk, you can rest assured); 7. In the “write mode” option, select “ldquo; USB-HDD+” or “USB-ZIP+”(Try to choose, can start the computer after production); U disk boot disk production tutorial (WinPE system) 8. Finally, click “write” Button, wait a few seconds, prompt "burn successfully", point, & ldquo; return & rdquo; button to exit, the end of production. Set the computer to U disk boot First insert the USB flash drive into the USB port (preferably plug in the USB port behind the host computer and temporarily unplug other USB devices), restart the computer, press "When the system just enters the self-test interface" ;Del” key to enter the BIOS settings, find the place to set the computer to start, such as "Advanced BIOS Features" or "Boot Device Priority", etc., corresponding to the boot U disk format, will be "First boot device" option For "USB" or "USB-HDD" or "USB-ZIP", press F10 to save, press Y to confirm, press Enter to exit BIOS setup, and the computer restarts again. Because of the different motherboards, the method of selecting USB boot is different. Some new motherboards, "USB-HDD", are selected in "Advanced BIOS Features", "Boot Seq & Floppy Setup", set the "First boot device" option to "Hard Disk". Then select your USB flash drive in the “Hard Disk Bot Priority” (the USB flash drive should be plugged in before booting). Xiaobian recommended "general pe toolbox v5.0 latest xp/win7/win8 universal version" This article comes from [system home] www.xp85.com