How to install battery management software under win10 Install battery management software graphic tutorial under win10

thinkpad power manager is a powerful battery management software that can effectively extend the life of the battery. The small block of the front battery has been used for four years. Under the condition of not connecting the AC pool, it can support nearly one hour at full load. Very powerful, this is the credit management software, but in win10, but the software is no longer available, so good software is not needed?

1. Enter Lenovo's official website and select the top service and support. On the next service page, select the think download center under the think service. A total of three ways to find the driver, host service number, install adaptive program, manually select the device model

2, Xiaobian does not like to install a program into the book, so use The method of selecting the model of the device, the model can be seen at the bottom of the front screen of the notebook, which is relatively intuitive. Of course, the service number can also be used. The service number is on a barcode strip on the back of the notebook, and the name is product ID.

3, using the above method to expand the search, the system will automatically list all the drivers supported by the model, select the corresponding operating system on the upper right side, such as win10, 64 or 32 bit two Select one, it will show a PM driver under, as shown below, you can download.

4, after the program is downloaded to the local hard disk, double-click to install, the system will prompt a directory to decompress, after decompression, it will enter the installation program, there is not much to be configured, just specify The installation directory can be used. After the installation is completed, the notebook should be restarted. There is not much change after startup.

5. Double-click the control panel of the desktop to enter the system, select <Hardware & Sound>, and then select the power supply selection. As shown in the figure below, you can find that after installing the above driver, the system has been added a few times. A power usage plan, such as energy saving, demonstrations, etc., but without previous battery optimization features.

6, if you look carefully on the official website, the operating system should not choose win10, but choose win7 operating system, in the search for the application software category, you can see the thinkpad power management software, as follows As shown in the figure, download it first

7. Double-click the software to download and download the self-extracting directory. You need to select the directory to release the downloaded exe file, and then you will enter The installation process, unfortunately as shown below, the system will prompt that the software does not support win10

8, has been tossing for so long, can not easily give up. Right click on the setup program and select the last line in the pop-up window <Properties>, the system will pop up the file properties window as shown below, see no, there is compatibility tab page.

9, select the compatibility page with the mouse, and then check the check box before running this program in the previous compatibility mode, then you can see many win10 systems in the drop-down box, select Win7 can be, this program is run in win7, after the selection is completed, click OK below.

10, the configuration is complete, pray for it, double-click the setup to install, this time very smoothly, did not jump out, enter the next step of the installation, select the language of the installation, define the installation directory, A blue progress bar appears and the installation is complete.

The above is how to install the battery management software under win10. Install the battery management software graphic tutorial under win10, I hope to help everyone!