How to shield five network functions - improve XP system speed

How to make Windows XP system achieve fast start has been the unremitting pursuit of computer enthusiasts. However, when we exhausted the tricks of various optimization systems, the progress bar in the system startup screen still needs to be rotated over a dozen times to start the system successfully. What is going on? Is it the various kinds summarized in the media? System optimization tricks are used to "fudge" In fact, many of the network setup functions hidden in the dark of the system are inaccessible to many system optimization tricks. In many cases, these improperly configured network functions slow down the system startup speed; for this reason, we only need to improperly If the network function is blocked, you will be able to speed up the system and add a whip!
1, shield automatic allocation function
mentioned here, "automatic allocation function", in fact, refers to the Windows system in the default state for the local network card device automatically assigns an IP address; once the local network card If the IP address is set to be automatically obtained, then each time the computer system starts, it will take a certain amount of time to apply for a dynamic IP address that can be used by the DHCP server in the LAN network. If the DHCP server is not accessed, the computer system will try again. Repeatedly connect and access the DHCP server until the access timeout, so the system startup speed will be very seriously affected, and even the system suspended state. In order to avoid the system taking time to connect and access the DHCP server during the startup process, we only need to set a static IP address for the NIC device in advance. To assign a static IP address to the NIC device, follow the steps below: Br> First click the “Start”/“Settings /“Network Connections”/“Local Connections” command to go directly to the local system "local connection" property setting interface, in In the “General” tab of the setting interface, select the “Internet Protocol (TCP/IP)” option and click the “Properties” button on the corresponding page to open the property setting interface. In the “Use the following IP address” option, specify the IP address of the same subnet as the ADSL device address for the NIC device; for example, the IP address of the ADSL device is generally “192.168.1.1” , then we can set the NIC IP address to "192.168.1.11", and set the subnet mask address to "ld 255" .255.255.0”, the gateway address is set to “192.168.1.1”.
Next, use the following DNS server address, select the local DNS server's real DNS server IP address here, for example, the ISP's real DNS address is "61.172.7.1" Then, we can fill in the address here, and click “ OK & rdquo;, in order to save the above IP address parameters, I believe that the computer system will not need to spend time in the future when starting DHCP server, then the system startup speed will definitely take it to the next level.