Load AHCI driver, let XP system say goodbye to boot blue screen

Friend call reflects his use of IDE mode to install XP system, open AHCI mode will appear the boot blue screen restart problem. It uses Zhaoyang K43---ICH9M, asks how to load the AHCI driver under XP, in order to open the BIOS AHCI option to play the best performance of the hard disk.

Problem Analysis

The xp system cannot directly support the AHCI hard disk high-speed mode. You need to load the AHCI patch before you can open the hard disk mode in the BIOS.

Solution:

Take the Zhaoyang K43---ICH9M used by friends as an example.

1. As shown in the figure below, this is the device manager when the AHCI driver (the chipset driver is installed) is not loaded.

2. We download the SATA driver and unzip it. As shown below:

3. Restart, modify the BIOS SATA working mode to AHCI option, the following modify the hard disk mode method is "AHCI", and some are Enabled or Disabled. As shown below:

(There is a reminder here: different models of the computer, the location and method of modifying the hard disk mode in the BIOS are slightly different)

4. When the system startup is completed The system prompts you to discover the new hardware wizard. As shown below:

Point to the path: the SATA driver root directory after decompression. As shown below:

5. Installation is successful: click Finish. As shown below:

The settings of the above steps are the most convenient way in the current online world. If your computer is also experiencing the above problems, why not try the easy-to-use solution?