Causes and Solutions for Fiber Dialing Problems under WinXP

  

Most homes now use fiber-optic access broadband, which is faster and more stable than traditional network connections. Since many friends have just come into contact with this kind of broadband, there are often some problems in the process of use. For example, installing the FTTB dialer under WinXP has the following faults:

Fault reason:

On Windows In XP, follow the steps in Windows 98. After installing the FTTB dedicated dialer, enter the user name and password, and the system asks to restart. After restarting the system, double-click the dialer. The strange thing is that it requires the author to establish a new connection again. In the past, under Windows 98, it was possible to dial up directly. Build a connection again, still.

Failure Analysis:

Since the system has been prompted to verify that some files cannot pass Microsoft's verification when installing the FTTB dialer, ask if you want to continue. At that time, Xiaobian chose "Yes". Therefore, Xiaobian suspects that the dialer provided by Telecom does not support Windows XP. Even if you download the latest version of the dialer, you can still fail. Will it be a problem with the NIC installation or setup? In the Device Manager, there are no issues such as exclamation points or conflicts, and the NIC is correctly identified. Then open the network neighborhood, found that in addition to the original "local connection" in the network neighborhood, there are two more "dial-up" dial-up connection with the red cross. These two connections were previously established, and the wrong connection shows the message "Dial-up disabled due to the network cable being unplugged or not properly connected." ? But I do not plug over the net cord before installing Windows XP, how will this prompt does

Troubleshooting:

Finally, Xiao Bian turned to China Telecom, the problem was solved . In Windows XP, you don't need to install any FTTB dedicated dialing program. You can use the dial-up connection that comes with Windows XP. If you install the FTTB dialer, you will encounter problems that I have encountered. The specific operation method is as follows: Click “ Start & Rarr; Program & Rarr; Attachment & Rarr; Communication & Rarr; New Connection Wizard & rdquo;, enter the new connection wizard interface, select “ connect to Internet → manually set my connection → Connect the name and password to the broadband connection, enter any ISP name, such as FTTB, and then click “Next” enter the username and password. Once you are done, double-click the FTTB connection icon in Network Neighborhood to access the Internet. Through this method, we can also be in a networked state like “Wired Communication”, so that you don’t have to dial every time you go online.

From the detailed analysis of the above small series and the shared solutions, the problem of fiber dialing under WinXP is not too difficult to deal with. As long as the user carefully observes the above analysis and processing methods, step by step, you can restore your fiber network to normal use.

Copyright © Windows knowledge All Rights Reserved