Easy to copy without using win7 as usual

Usually installing Win7 is done through the Win7 installation CD, but the installation speed of the installation CD is slow, and the installation CD is not easy to carry, it is also easy to damage, if you want to help others install the system or install multiple computers at the same time In fact, the system installation can be simpler ——“copy” is OK!

Repair boot automatically completes according to the prompt

A copy will appear after the copy is completed Prompt window, prompt "If the boot sector has no boot information after recovery, the system may not be able to start. Are you using the following parameters to fix the [C:] boot information? & rdquo;, be sure to click “ Yes & rdquo; Repair.

After the operation is completed, copy the files in the root directory of the Win7 installation CD (or image file) in the WinPE directory to the directory root of the C drive.

Now, there is already a Win7 system in the C drive. If it starts, it will prompt an error. It doesn't matter, use the Win7 installation CD to start the computer. When you go to the “Install Now” step, select the interface below. “Repair the computer”, then select “fix and restart", and you will be able to fix it and restart it automatically. At this point, the CD is removed and the system can boot from the hard disk.

After the computer restarts, just like running the system for the first time, update the registry settings, start the service, install the device … …

using this method, from copying the system files to successfully entering The desktop, which took less than 15 minutes in total, saves half the time compared to the traditional method of installing CDs (it is faster if you use Win7 image files)! You only need to prepare a WinPE CD (or WinPE flash drive). ), a Win7 installation CD (or Win7 system image file) and "ImageX one-click recovery" software.

System “Copy” ImageX to help

Why doesn't the system need to be installed, just need to copy ” can be used? In fact, the Sources directory of the Win7 installation CD has A file named “install.wim” that contains one or more operating systems that have been installed. In other words, Microsoft has actually installed the operating system. We just use ImageX to copy the installed system from the CD-ROM to the hard disk, and then configure the boot entry for the operating system that is copied & rdquo; Can complete the installation of the system, it is so simple!

Master Dong Tip: Pure copying and pasting is of course not possible, which is why you should use ImageX. ImageX will automatically decompress the content we need in the “install.wim” file during the "copy" process.

Also, using ImageX requires manual formatting of the hard disk partition before the operation. If the hard disk does not yet have a partition, start it with WinPE CD, use the application on the CD (such as DiskGenius) to partition the hard disk, set the C drive as the active primary partition and format all the partitions. If the hard disk is already partitioned, format the C drive.

However, using the original ImageX program to run in a DOS environment, and to enter some DOS commands, this is too "for the average user". It doesn't matter, we can use another software ——“ImageX one-click recovery" (also called "GGhost one-click recovery"), which has integrated ImageX. Through it, the entire operation process can be completed in the graphical interface, the user only needs to click the mouse as needed. Previous123Next page Total 3 pages