WinXP system how to reset the network through the cmd command

Sometimes computer poisoning, network card driver error, network instability and other factors will cause the computer can not access the Internet, the easiest way is to reset the network, how to pass the cmd command Network reset? Let’s take a look.

The specific method is as follows:

First, reset the network setting command

Start → Run → Input: CMD Click OK (or press Enter) to open the command Prompt window.

at the command prompt, type: netsh winsock reset (press Enter to execute the command).

Later, there will be tips for success: Successfully reset the Winsock Catalog & rarr; restart the computer to complete the reset.

network anomalies, usually caused by network card driver does not match, you can try again to update the NIC driver to match. The steps are: start → control panel → system & rarr; device manager & rarr; network adapter & rarr; right click NIC device & rarr; update driver.

Second, the wireless network anomalies

In addition to updating the NIC driver, and wireless services are open questions. The check steps are: Start → Run → Enter: services.msc Click OK (or press Enter) to open the service.

turn found: Wireless Zero Configuration (wireless service) & rarr; Startup Type & rarr; automatic & rarr; application & rarr; start & rarr; OK.

If your wireless card is built, it is possible in the BIOS was closed. Restart the computer, press the button to enter the BIOS (generally pay attention to the first screen of the boot, there will be a prompt to enter the BIOS key).

Select (the menu may vary) Device & rarr; Network Setup. After

Select Onboard Ethermet Controller press the Enter button, and then press Enter to select Enabled option button; set up, press the F10 key to save the settings, select YES option and press Enter button, the computer will restart at this time The BIOS NIC switch is turned on.

Those are the small as we explain WinXP system reset network command methods, like more exciting tutorial Stay tuned to this site!