Win10 system prompts can not display this page in the advanced settings to enable TLS 1.0 solution

Now, most of the switches are managed, you can easily manage them through the web interface. However, some users encountered a "Cannot display this page" when logging in with a browser. Prompt to enable TLS 1.0, TLS1.1, and TLS1.2 in the advanced settings, and then try to connect to https again. 10. What should I do? The following small series will share the specific solution to the problem.
Workaround:
1, open the login switch management ip login prompt, ask us to open tls;

2, the mouse is right to click on the right to select the control panel;
< Br> 3, select the internet option in the control panel;

4, click the advanced tab in the internet option;

5, then pull down the middle slider to find the following figure And tick tls2.0, tls3.0;

6, then we open the switch management ip login and found that you can enter the management page.

The above is the introduction of the win10 system prompt can not display this page in the advanced settings to enable TLS 1.0 solution, the friends who encountered the same problem, you can follow the above steps to see.