The XP system always prompts that the memory cannot be written for how to solve it?

In the process of using XP system, it is inevitable that some problems will be encountered. For example, some users have been automatically popping up XP system memory when they are running some relatively large programs or games. The error message, what is going on? How to solve this problem? The following small series for everyone to introduce XP system always prompts that the memory can not be written solution.

steps:

1, first of all, to see what the operating system's virtual memory settings in which partition? This is because the Windows operating system generally sets virtual memory in addition to physical memory. The steps to view are: Start → Control Panel & Rarr; System.

2, the system attribute & rarr; Advanced & rarr; performance & rarr; settings.

3, Performance Options & rarr; Superior & rarr; virtual memory & rarr; changes.

4, you can see the page file (virtual memory) from the chart is located in the C disk defragmentation is necessary to analyze the C drive.

5, defragmentation step: Right-click on the system disk (usually drive C) & rarr; property.

6, C disk properties & rarr; Tools & rarr; defrag & rarr; began to organize.

7, click the partition where the virtual memory & rarr; analysis (install, uninstall the software will generate a lot of debris, run the program step on an error occurs in the debris).

8, if a computer has never finishing off debris, then there must be a lot of red in the area. Look at this picture, the upper and lower contrasts will know the situation before and after finishing.

9, if after finishing, or after analysis, suggesting no need to change defragment a volume, you can exclude memory error caused the problem can not read and write.

10, may wish to use the command for all of the dynamic chain a re-registration, to correct errors in the file system.

11, start → run → input: CMD Click OK (or press Enter) to open a command prompt window.

12, after opening the CMD window, type the following command (carriage return execution), to re-register at all dynamic chain (this process may be long):

for% 1 after in (.% windir% \\ system32 \\ * dll) do regsvr32.exe /s% 1

13, using the same method to register the component, two runs were completed to restart the machine:

for% 1 in (% windir% \\ system32 \\ *. ocx) do regsvr32.exe /s% 1

above is Xiaobian to introduce XP system is always prompt The memory cannot be a written solution. If the user encounters the above situation, you can follow the above steps.