HDMI external output settings under Windows XP system

                  Problem Description
Users call advice ideapad Y330A external HDMI how to set

Problem Analysis
ideapad Y330A
Windows XP sp3 Professional Edition
Note:

Plug and play external It is recommended to power off the HDMI interface of the monitor and notebook

Solution
1. Connect the display device with HDMI cable and Y330A

2. Switch the external display device to HDMI after connecting. Display mode of interface

3. Right click on the desktop and select “Catalyst Control Center” to open the ATI console. The welcome setting interface (Figure 1), select Advanced, and the next step.




Figure 1

4, the notice clicks "Yes" (Figure 2)


Figure 2


5, enter the ATI Catalyst Control Center to see that the HDMI external display device has been detected (disabled state) (Figure 3)



Figure 3

6. Double-click the gray display 2 (Figure 4) to pop up the Enable Device prompt and select "Yes". (Figure 5)


Figure 4



Figure 5


7, at this time, the display device of external display device appears, ATI Catalyst Control Center application selected, the pop-up prompts to select "Yes" (Figure 6)


Figure VI


8, adjust the display mode is shown seven, right-click enabled The external device selects the corresponding mode. (Figure 7)


FIG seven


9, directly after the connection is automatically switched to the audio output HDMI output. (Figure 8)


figure VIII


10, if required using a laptop with an external device to watch 1080P high-definition video, advise users to adjust the display mode to "extend the desktop level '( Figure 9), select the display 2 to adjust the resolution to 1920 * 1080 to achieve the perfect point-to-point display 1080P for external devices. (Figure 10)


Figure 9



Figure 10