The protection system 6.0 cannot perform the incremental simultaneous transmission. The

protection system 6.0 enters the network simultaneous transmission interface. The incremental simultaneous transmission is gray, and the incremental simultaneous transmission cannot be performed. (Figure 1)


Figure 1

what reasons, and what interpretation should be noted that the increment?

Solutions by
The simultaneous data transmission is carried out after a successful data simultaneous transmission (the first time must be the simultaneous transmission of data of all the partitions), on the original basis, the valid data of the original transmission end is transmitted to the receiving end computer. It can avoid repeated transmission of resources and improve work efficiency.
If you find this function as gray option, you can consider the following aspects:
1, this is gray when the first simultaneous operation. You must do the same data pass-through for all partitions first.
2, to ensure the existence of incremental data.
3, must enable the hard disk protection system.
4, the hard disk partition where the incremental data is located is in protected mode.
5, the sender adds incremental data also needs to be in protected mode, and immediately after the restart, incremental simultaneous transmission, otherwise the incremental data will be restored by the hard disk protection system.
6, using the same computer as the transmitter.
7, the receiving end is the same from the transmitter end of the system.