How to set the IPV6 address in Win7 system? Method of setting the IPV6 protocol address

IPV6 (Internet Protocol Version 6) is a next-generation IP protocol designed by the IETF (Internet Engineering Task Force) to replace the current version of the IP protocol (IPV4). In the Win7 operating system, how to set the IPV6 protocol address? What is the method for setting the IPV6 protocol address? Let me introduce the method of setting the IPV6 protocol address in Win7 system.

The method is as follows:

1. Install the IPv6 protocol: Open the Control Panel and go to “Network and Internet” and click “Connect to “Local Connection”. In the pop-up properties dialog box, click Install, then select “Protocol", click Add, you can install IPV6 into the project list. After the installation is completed, as shown below:

2. Set the IPV6 address: Open the control panel, and then go to <; Network and Internet>- “Network Connection” - Right-click “Local Connection” In the pop-up properties dialog box, double-click "Internet Protocol Version 6 (Tcp/IP), select Manual in its property box, and enter the IPV6 address "3FFE:FFFF:7654:FEDA:1245:BA98:3210:4562” (due to IPV6 is in the test phase, so it can be freely entered to determine its address).

3. Test IPV6 settings: Press “Win+R” to open the Run dialog. Enter CMD and enter the “ipconfig” command in the pop-up MSDOS window to view the configuration of all local IP addresses.

4, configure the ISATAP tunnel, after completion, open the browser, enter the URL "http://ipv6.jmu.edu.cn/” conduct IPV6 test, on the page, if you can see A dancing tiger means you are visiting the page with IPV6. If the tiger does not dance, you will visit the page with IPV4.

The method of setting the IPV6 protocol address on Win7 system is introduced to you in detail. If you do not know how to set the IPV6 protocol address, you can refer to the above method and follow the steps to complete the IPV6 protocol address. Is it very simple! Let's try it!