Cancel the Win7 computer boot automatically detects the hard drive's five coups

Cause analysis:

1, may be caused by illegal shutdown, such as direct power off;

2, hard disk bad sectors There will also be a phenomenon in which the hard disk is automatically detected at boot.

3. It is related to the partition format of the hard disk. The FAT32 format will require the hard disk to be detected at boot time after the illegal shutdown, and it must be detected before it will be re-detected at the next startup. It can be seen in the system. A file records information about whether the detection is over. Sometimes, even if the detection is completed, it will be re-detected the next time it is turned on because the file is not updated.

Solution:

Method One, or you choose to check the hard disk every time you boot in the BIOS settings, it has nothing to do with your computer configuration. Solution After booting, press DEL to enter the BIOS and select Quick Power On Self Test. You must be set to Enabled. Select Disabled and turn it off.

Method 2, if the partition is in FAT32 format, it is recommended to convert it to NTFS. The operation method is to open a command prompt and type: convert X: /fs:ntfs, press Enter;

Method 3: If it is due to abnormal shutdown, if it is skipped every time, it will still run. If it is not for this reason, it is necessary to check whether the D disk status is normal. Correct the hard disk error. To do this, click on "Start”→“Run", and enter “chkdskX:/f” (x is the drive letter) in the window. This command can check the logic errors in the file system and fix them. Then start "Disk Defragmentation" to defragment the corresponding disk, which can eliminate the disk scan again. If it is not possible, there may be bad sectors on the hard disk. The easiest way is to back up the data of the D disk. Then format the D drive so that it works.

Method 4: Modify the registry, open the registry and navigate to [HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet /Control/Session Manager], and find “BootExecute:REG_MULTI_SZ”” in the window on the right. The key value is Windows on the disk scan, double-click "BootExecute: REG_MULTI_SZ"; change its content to: "autocheck autochk *", press Enter to restore the normal state, or delete all the numerical data inside, so that you can thoroughly It is forbidden to run ScanDisk when it is illegally shut down and restarted.
Cancel the five tricks of Win7 computer to automatically detect the hard disk

Method five, open "Computer", then right click on the X disk to select "Attributes" - select "Tools" - "-" Wrong & rdquo; midpoint & ldquo; start check & rdquo; - check "automatically fix file system error" and "scan and try to recover bad sectors", then click "start" to perform scan repair;