WinXP lower right corner prompts to delay write failure files may be damaged or lost

WinXP is a mature system, but it is still prone to failure during use. There is a problem when users use XP system: Windows from time to time in the lower right corner of the screen will prompt Windows - Delay write failure Some files may be damaged or lost. At this time, if you run some software, it will not work. What is the cause of this? How to solve?

Through the research of a large number of computers, there are three main reasons for the above failures: 1. Frequent forced shutdown operation; 2. System file error; 3. Hard disk has bad sectors causing file errors. 4, memory failure For these reasons, the system box Xiaobian talk about the solution.

One, multiple forced shutdown or normal restart caused

1. Click the start menu in the lower left corner, select the run option, then enter CMD and press Enter;

2 In the CMD window, enter: CHKDSK C:

Second, the system file error

1. Open my computer, open the local disk properties, select [ in the pop-up dialog box. Tools]--[Start Check],

2. In the Check Disk dialog box. Check the following two items (XP system download www.xitonghe.com/XP) check it. Just fine, if you can't solve it, look below.

3, open the [local] Disk Properties dialog box, locate the [hardware]

4, [strategy] to open the dialog box, the [written on the disk to enable Cache] The previous check is gone.

Third, the hard disk appears physical bad sectors

Because the long-term use of the hard disk will be scratched on the surface of the disk like a CD, but the image metaphor is actually not so serious, XP system is Can not handle the physical bad sectors of the disk, this time the best once and for all solution should be to replace the hard disk. The following small series first teaches you to test your hard drive bad track is not serious.

1. Use the U disk boot disk or boot CD to run the MHDD bad track detection tool inside;

2, then select the hard disk you want to test, enter the serial number and press Enter;

3. Enter SCAN. After a small window appears, press F4 to start detecting the hard disk.

4, the red small block or the red fork is bad, and generally if the damage is at the beginning of the disk, it is difficult to repair, even if the system is reinstalled, it will be very easy to make mistakes, and if it is bad There are not many roads, and in the latter part, you can use the partitioning software to shield. Compared with the previous one, you can see the percentage of the hard disk. If there are too many bad sectors before the 10% experience, the disk can not be used as the system disk. used.

5, if there are not many bad sectors, we can also use the Diskgenius partition software to isolate the bad sectors, we enter the PE to enable the partition tool DISKGENIUS.

4, through the results of the test just now, calculate the capacity of the bad sectors. Use the partitioning tool to separate the parts with bad sectors. Put the good one out and use it, but don't put important data on this hard disk.

Note: Physical bad sectors will spread. If the hard disk is still under warranty, please guarantee it as soon as possible.

Fourth, memory failure

Memory as an important part of the data exchange in the system, if there is instability, then the exchanged files are likely to have bad sectors, errors, due to the particularity of memory In general, if you find that there is a problem with the memory, you can only replace it directly.

WinXP's lower right corner prompts to delay write failure. This article analyzes four reasons. For these reasons, see the move, and each proposes a solution. You must check the number to solve the problem effectively.