Windows Vista blue screen code meanings and solutions

Vista blue screen is not a new topic! A lot of English in the face of blue screen, sometimes it will be overwhelming! Today we will look at the blue screen code meanings and solutions we have compiled …… Br>

1,0x0000000A:IRQL_NOT_LESS_OR_EQUAL

Error Analysis: Mainly caused by problematic drivers, defective or incompatible hardware and software. From a technical point of view, indicating presence in kernel mode Too high process internal request level (IRQL) access to memory addresses that it does not have access to. ◇ Solution: Try to exclude using the 2, 3, 5, 8, and 9 solutions in the solution described above.

2, 0x00000012: TRAP_CAUSE_UNKNOWN

Error Analysis: If you encounter this error message, then unfortunately, the result of KeBudCheck analysis is that the cause of the error is unknown. ◇ Solution: Since Microsoft can't help, You have to rely on yourself, please think carefully about when this error occurred; what did you do to the system when it first occurred; what was happening when it happened. Find out from this information. The reason for choosing the corresponding solution to try to exclude.

3, 0x0000001A: MEMORY_MANAGEMENT

Error Analysis: This memory management error is often caused by hardware, such as: newly installed hardware, memory There are problems in itself. ◇ Solution: If it appears when installing Windows, it may be because your computer does not meet the minimum memory and disk requirements for installing Windows.

4, 0x0000001E: KMODE_EXCEPTION_NOT_HANDLED

Error Analysis: The Windows kernel has detected an illegal or unknown process command. This stop code is usually caused by the memory of the problem or a similar reason to the previous 0x0000000A. Solution: (1) Hardware compatibility is problematic: Please check the latest hardware compatibility list mentioned above to see if all hardware is included in the list. (2) Problematic device driver, system service or memory conflict and interrupt conflict: If the driver appears in the blue screen message Name, try disabling or removing the driver in the installation mode or the Recovery Console and disabling all newly installed drivers and software. If the error occurs during system startup, please enter safe mode, rename or delete the file indicated in the blue screen information. (3) If the error message clearly indicates Win32K.sys: It is likely to be caused by third-party remote control software. The software needs to be shut down from the Recovery Console. (4) When the first reboot after installing Windows: The biggest suspect may be when the system partition has insufficient disk space or BIOS compatibility. (5) It appears when you close a certain software: When there is a possibility that the software has a design flaw in the province, please upgrade or uninstall it.

5, 0x00000023: FAT_FILE_SYSTEM0x00000024: NTFS_FILE_SYSTEM

Error analysis: 0x00000023 usually Occurs when reading or writing the system partition of the FAT16 or FAT32 file system, and 0x00000024 is due to an error in the NTFS.sys file (this driver file is used to allow the system to read and write to the disk using the NTFS file system). These two blue screen errors are very There may be physical damage to the disk itself, or interruption of the request packet (IRP). Other reasons include: hard disk fragmentation File read and write operations are too frequent, and the amount of data is very high or caused by some disk image software or anti-virus software. Solution: First step: first open the command prompt, run "Chkdsk /r" : Not CHKDISK, it feels like this, but the ……) command checks and fixes hard disk errors if there are bad sectors reported.