How to solve the problem that WinXP front audio has no sound?

We all know that the audio jacks of general computers have two groups of front and rear. Recently, after the user assembled his own computer, he installed the WinXP system. He wanted to listen to the song and found that there was no sound when the front jack was plugged into the earphone, and the back socket had a sound. What happened? Below, Xiaobian will talk to you about how to solve the problem that WinXP front audio has no sound.

The steps are as follows:

1. Plug in the rear of the computer chassis. The sound of the audio interface indicates that the computer sound card and the driver are all normal. There are three main types of sound in the front chassis of the computer. may. First of all, we must analyze the structure of the audio interface of the front chassis. The front audio of the chassis has a set of audio cables. When installing the computer, you need to connect the audio cable to the audio output port of the motherboard. There is no sound in the front audio output of the chassis. It may be caused by the audio cable not being inserted into the corresponding output interface of the motherboard.

2, if the system is set to disable the front audio interface, it will also lead to no sound in front, and I have encountered many systems, the default is to disable the front audio interface, and generally go to the computer to install the machine Computer City staff will generally plug in, it is not easy to forget, the following describes the solution:

3, from the simple start, first check whether the disabled "front panel detection" function, enter the computer desktop In the lower left corner, Start - Control Panel - select "Sound, Voice and Audio Devices" - "Realtek High Definition Audio Configuration".

4, enter the "Realtek high-definition audio configuration" interface, select the switch to the top of the "audio I /O" tab, and click the “ simulation panel & rdquo; settings icon.

5, first switch to the "audio I /O" option, and then there is a setting tool on the right side of the "simulation back panel", click to enter the settings, in the pop-up panel will be "disabled" The front panel detection & rdquo; can be marked on the front, then select OK to confirm.

6. If the above settings still have no effect, you can open the computer case and check whether the audio cable of the front chassis is plugged into the main audio output interface, check whether the plug is correct and correct, etc. There are two problems with setting up the cable. Of course, some people may suspect that the audio port of the chassis is damaged or defective. This is possible, but for newly assembled computers, the basic probability is very small.

On the question of how to solve the problem that WinXP front audio has no sound, I will introduce it to you in detail. If you are experiencing such a problem while listening to songs on your computer, you may wish to follow the above method. I hope to help more people with problems here.