The operating system can't enter. Teach you to retrieve the important files of the C drive

                  How can I not enter the operating system? I also have customer information, reports to be submitted next week are on the desktop! I can't always get started on the backup computer ……

Have you experienced the above situation? Sometimes, installing crack software, or using the hard disk partitioning software inadvertently, may result in failure to enter the operating system after restarting the computer. However, when we use a computer, it is a common thing to put some documents and materials on the desktop for the sake of convenience. When it is unable to enter the operating system due to careless use, these files will be lost due to the reinstallation of the system formatted hard disk. So, is there any way to retrieve these important documents and materials?

WinPE can be said that the best way to solve this problem. WinPE can be seen as a highly simplified operating system that can be booted from a CD or a USB flash drive, accessing a hard disk, formatting a hard disk, and so on. By accessing the hard disk of a computer that cannot enter the operating system normally through the WinPE system, important data can be backed up.





Windows PE

In the past, all Ghost XP installation CDs had WinPE, but now, the usage of CDs and CD-ROMs has been greatly reduced, and the number of people who keep Ghost XP CDs . Today, the author teaches you to use WinDisk to create WinPE. First need to find a working computer, download the old peach WinPE (click me to download), double-click to install after the download. Then connect the USB flash drive. It is recommended to use a USB flash drive with a capacity of 4 GB or more to prepare WinPE in the USB flash drive.

The production of WinPE

The production process of the old peach WinPE is very simple. Need to be reminded that the data in the U disk should be backed up, because the production of WinPE needs to format the U disk. Connect the U disk and the computer, start the old peach U disk boot disk creation tool, directly click "One button to make a USB boot disk", the software will prompt "This operation will format the U disk", click “ & rdquo; Continue, the next step is to wait a little while until the prompt "made" & rdquo;.
Click “One button to make USB boot disk”
Finished

WinPE use

Next, U disk and not normal The computer that enters the operating system is connected and booted into the BIOS. Depending on the model, you may need to press a button such as DEL, F2 or F12. At the time of booting, pay attention to the lower left corner of the screen, usually there will be a prompt to press which button to enter the BIOS.
Selecting a USB device in the BIOS to boot

After entering the BIOS, we need to select the USB device to boot; some computers may need to set the boot sequence of the hardware, and then save the BIOS to restart the computer. After selecting the USB device to boot, the computer will enter the interface shown in the figure below, and the corresponding function can be accessed by pressing the number key marked in the brackets before the item. For today's theme, we only need one of the first three. I recommend choosing the classic version (acceleration mode), which has a higher success rate and is faster.