A comprehensive introduction to the new method of restoring the GHOST system


Everyone tried to install the computer by themselves. The problem of the computer system is more or less known. If you can't get into the system, the average user will want to restore the system, but how to restore it is the most convenient? Try to restore with a USB flash drive, you can restore it with one click.

First, installation:

The so-called "USB flash drive", this software refers to all USB disks, including ordinary U disk, MP3/MP4 player, USB card reader (including memory card) , USB mobile hard disk.

For the convenience of description, the following is collectively referred to as "U disk". In addition, there is almost no requirement for capacity, 16MB or more.

Download, unzip.

Installation steps:

1_Initialization (In general, the U disk is initialized at the factory, this step can be skipped.) Initialization is the amount provided by the U disk chip manufacturer. Production tool/user management tool, low-level operation of U disk, etc. When the U disk has serious problems, it can make the U disk come back to life; the partition/format function of the management tool can improve the boot success rate. How to use: (Each U disk uses different chips, so the tools used are different, generally have their own instructions.)

2_boot settings (2010 version of the new method, different from 2009 and earlier, most Steps are required.)

Related files: 2_boot settings.exe

Specific steps: as follows.

(1) Fully formatted: Insert USB drive-> Double click "My Computer (Computer)"-> Right-click U Disk->Format->" File System" Select FAT32 or FAT or NTFS (do not select exFAT)-> GHOST->Do not select "Quick Format"->Start. Note: Formatting will delete all data, please make a backup of the data file in advance.

(2) Select the target disk: re-plug the U disk, double-click "2_Set boot.exe" to enter the BOOTICE main interface, [target disk] will automatically detect the local hard disk and USB disk, In general, the first U disk will be automatically located. If you do not automatically locate your U disk, please select the U disk manually. There are four buttons below the main interface, [Main Boot Record], [Partition Boot Record], [Reformatting] We will use it next.

(3) [Reformat]->USB-HDD mode (single partition)->Next->FAT32 (or FAT or NTFS), note: must be the same as "fully formatted""filesystem"->OK->OK->Close (return to main interface), re-insert U disk.

(4) [Master Boot Record]->UltraISO USB-ZIP+->Installation/Configuration->OK->OK->Close (return to the main interface)

Copyright © Windows knowledge All Rights Reserved