Close the idle IDE channel to improve the operating efficiency of the win2008 system. The

Windows 2008 system is well received by users due to its high security, strong reliability and very strong stability, but with the increase of usage time, users It is found that the operating efficiency of the system is getting lower and lower, and there are many factors that cause this phenomenon. The following is a trick for the master to teach everyone to close the idle IDE channel to improve the operating efficiency of the system. Close the IDE channel to improve the efficiency of windows2008: In general, WindowsServer2008 system will automatically load all hardware devices during the startup process. This process will consume a lot of resources and waste a lot of time; in fact, the system does not We rarely use hardware devices. Turning off these idle hardware devices can effectively improve the efficiency of the server system. For example, when we open the device manager window of the system under Windows Server 2008, and expand the "IDEATA/ATAPI controller" project, we can see that the system contains two IDE channels, which are under the old version system. Called the main IDE channel, the secondary IDE channel; however, in the WindowsServer2008 system environment, the IDE channel has no primary and secondary points. Considering that many ordinary friends usually use only one hard disk device in their computer, we can completely shut down another IDE channel that is idle to improve the system startup speed. When turning off the use state of the idle IDE channel, we can right-click one of the IDE channel options in the device manager list window and execute the “property" command from the shortcut menu that pops up to open the corresponding IDE. The property setting interface of the channel; click the “Advanced Settings” tab in the setting interface to enter the label setting page; in the setting page, we can see the specific transmission mode of the current device, which indicates that the IDE channel is currently It is used while the other IDE channel is idle. At this point, right-click on another IDE channel that is idle and execute the “Uninstall” command from the shortcut menu, so that the idle IDE channel can be closed. After a long time of use, the system runs slowly. There are many reasons for this situation. Users need to organize them in time. The above-mentioned shutdown of the idle IDE channel is only a small aspect of optimizing the operation efficiency. To ensure that the system runs more efficiently, it needs to be combined with other aspects of the system to be feasible.